FESTOOL Parallel Guide System For Consistent Repeatable Cuts

The Festool Parallel Guide System lets you make consistent rip cuts with ease and efficiency. This is an ideal accessory if you need to make multiple identical pieces out of one longer board. They can be used with any length of Festool FS/2 guide rails.

The Parallel Guides are the longer sections and offer consistent rip cuts using two adjustable stops that engage the edge of the material parallel to the cut line. They are adjustable up to 25-19/32″ (650mm).

The Parallel Guide Extensions connect to the Parallel Guide using a thumb screw (no tool required). The Extension allows you to make narrow repetitive rip cuts ranging from 1/16″ to 7-11/16″ (1mm to 195mm). The Extensions must be used in conjunction with the Parallel Guide.

Parallel Guide Extension Set (#203160) consists of the Guide (201182) and the Extension (#20183).

Once calibrated, the parallel guides have the precision to cut all your material to the final dimensions – no need to recut the material completely. You can even use the guides in tandem with Festool clamps if you install the clamps on the rail before attaching the parallel guides.

Guide Rail sold separately.